WORK PLANS - Laserfiche WebLink

Home Browse Search

0 0 Personal Protection Equipment Based on the preliminary site information including evaluation of the hazards at the site and Partner's experience, personal protective equipment(PPE)will be required for all personnel and visitors entering the controlled portion of the site. PPE for each potential level of protection is described below. Both Level C and D PPE should be available on-site during all phases of the project, as conditions may change and require additional PPE. Work should be conducted in Level D and no breathing protection will be required as long as monitored breathing zone vapor concentrations remain in the nominal operation action level. If on-site personnel find that breathing zone concentrations remain above nominal operation action level for more than 5 minutes,then the SSO or PM will make a determination if breathing protection is needed. At this time, all work in the affected area should be suspended until a decision is made. Implementation of Level C PPE will be required if work continues during elevated breathing zone concentrations. Donning and use of respirators shall be performed in accordance with manufacturer specifications. Replacement of respirator cartridges shall be performed in accordance with manufacturer specifications.All respirators and cartridges shall be stored in air tight bags while not in use. Please refer to the PPE Levels of Protection for a detailed description of the equipment associated for each level of PPE. PPE Levels of Protection Level D(to be used at all times) is as follows: Level B(used as appropriate) is as follows: • Full-length pants and shirt; • Positive-pressure, full-face piece, self-contained • Sturdy steel-toe work boots; breathing apparatus (SCBA) or positive-pressure • Hard hat; supplied air respirator with escape SCBA • Safety glasses. (NIOSH-approved); • Disposable chemical-resistant coveralls Modified Level D(used as appropriate) is as follows: (Polycoated Tyvek); • Regular Tyvek coveralls; • Outer gloves: neoprene or nitrile; • Outer gloves: leather, cotton, or nitrile; • Inner gloves: latex or nitrile; • Inner gloves: latex or nitrile; • Sturdy steel-toe work boots; • Sturdy steel-toe work boots; • Petroleum-resistant covers over work boots; • Hard hat; • Hard hat. • Safety glasses. Level C(used as appropriate)is as follows: • Half-face air purifying, canister equipped respirator (NIOSH-approved) equipped with Organic Vapor/HEPA cartridges/filters; • Regular Tyvek coveralls; • Outer gloves: leather, cotton, or nitrile; • Inner gloves: latex or nitrile; • Sturdy steel-toe work boots; • Hard hat; Decontamination Procedures Drilling and sampling equipment will arrive decontaminated and clean. All downhole soil and groundwater sampling equipment(e.g., sampling tubes, split spoons,hand augers,Hydropunch,etc.),tools,purge pumps,water level indicators, etc. will be decontaminated before, between, and after use with Alconox or an equivalent Partner Site-Specific Health and Safety Plan Page 4 Version 1.02 June 12,2018