Laserfiche WebLink
• Position one of the two sensing chamber cover plates over the open front of the <br /> sensing chamber with the dull surface on the inside, and such that the hole in <br /> the plate is aligned with the corresponding threaded mounting hole on the <br /> upper wall of the sensing chamber. Insert and tighten firmly black socket head <br /> screw provided with the conversion kit, making sure that the plate is aligned <br /> perfectly with the top of the sensing chamber. Similarly, attach the other cover <br /> plate to the rear of the sensing chamber,with the dull surface facing inward; <br /> • Loosen and remove the two small screws on the top surface of the sensing <br /> chamber; <br /> • Position large protective bumper (provided in the conversion kit) over sensing <br /> chamber pushing down until properly seated. Insert-the two top screws (two <br /> shiny Phillips-head screws provided in the conversion kit) Into the two holes In <br /> the bumper while holding down the bumper, and tighten gently (do not over- <br /> tighten) making sure that the heads of these screws are well Inside their cavities <br /> In the bumper; <br /> • Perform a zeroing sequence (see Sections 6.5.1 and 8.1) before starting a run. <br /> This completes the conversion from a pDR-1200 to a pDR-1000AN. <br /> 35 <br />