COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM (Page 4 of s) VIII . ` MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? © ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, 0 ❑ ❑ functional) tested, and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with © ❑ ❑ their proper operation ? Was monitoring system set-up reviewed to ensure proper settings ? ® ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested, and confirmed operational? W1 ❑ El Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? V1 ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically © El ❑ disconnected ? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? W1 El Which sensors initiate positive shut down? (Check all that apply.) © Sump © Under-Dispenser Containment 1:1 If alarms are relayed to a remote monitoring station, is all communications equipment (e.g . , modem) operational? 0 El ❑ For any answer of "N" above, describe in Section IX how and when these deficiencies were or will be corrected. IX. COMMENTS Replaced TLS Battery for Pm Purpose. Disp 7/8 has outer cable showing inner cable . Tried to replace sensor but it is epoxied in place . Sensor is functioning . X. IN -TANK GAUGING TESTING Check this box if tank gauging is used only for inventory control . (Do not complete this section) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be com leted if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ❑ ❑ El round faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally ❑ ❑ ❑ tested , and confirmed operational? Was accuracy of system's product level readings tested? ❑ I ❑ ❑ Was accuracy of system's water level readings tested? ❑ ❑ ❑ Were all probes reinstalled properly? ❑ 1 ❑ ❑ Were all items on the equipment manufacturer's maintenance checklist completed ? ❑ I ❑ ❑ For any answer of "N" above, describe in Section X/ how and when these deficiencies were or will be corrected. XI . COMMENTS j Y = Yes, N = No, NA = Not Applicable I