Laserfiche WebLink
Data Qualifiers and Definitions <br /> Qualifiers <br /> B Analyte was present in an associated method blank. Associated sample data was reported with <br /> qualifier. <br /> B1 Analyte was present in an sample and associated method blank greater than MDL but less than <br /> DRL. Associated sample data was reported with qualifier. <br /> BQ1 No valid test replicates.Result may be greater. Best result was reported with qualifier.Sample toxicity <br /> possible. <br /> BQ2 No valid test replicates. <br /> BQ3 Minimum DO is less than 1.0 mg/L. Result may be greater and reported with qualifier. <br /> C Laboratory Contamination. <br /> D The sample duplicate RPD was not within control limits,the sample data was reported without further <br /> clarification. <br /> DW Sample result is calculated on a dry weigh basis <br /> J Reported value is estimated <br /> L The laboratory control sample(LCS)or laboratory control sample duplicate(LCSD)was out of control <br /> limits. Associated sample data was reported with qualifier. <br /> M The matrix spike(MS)or matrix spike duplicate(MSD)was not within control limits due to matrix <br /> interference.The associated LCS and/or LCSD was within control limits and the sample data was <br /> reported without further clarification. <br /> NC The analyte concentration in the sample exceeded the spike level by a factor of four or greater,spike <br /> recovery and limits do not apply. <br /> P Sample was received without proper preservation according to EPA guidelines. <br /> Q1 Analyte Calibration Verification exceeds criteria and the result was reported with qualifier. <br /> Q2 Analyte calibration was not verified and the result was estimated and reported with qualifier. <br /> Q3 Analyte initial calibration was not available or exceeds criteria.The result was estimated and reported <br /> with qualifier. <br /> Q4 Analyte result out of calibration range and was reported with qualifier <br /> S The surrogate recovery was out of control limits due to matrix interference.The associated method <br /> blank surrogate recovery was within control limits and the sample data was reported without further <br /> clarification. <br /> T Sample was extracted/analyzed past the holding time. <br /> T2 Sample was analyzed ASAP but received and analyzed past the 15 minute holding time. <br /> TIC Tentatively Identified Compounds <br /> Definitions <br /> DF Dilution Factor <br /> MDL Method Detection Limit <br /> ND Analyte was not detected or was less than the detection limit. <br /> RDL Reporting Detection Limit <br /> f <br /> Or <br /> ASSOCIATED LABORATORIES Analytical Results Report r;l <br /> 27848-01 Lab Request 348558,Page 4 of 4 <br />