Laserfiche WebLink
Hydrostatic Sensor Installation Guide Dual -Paint Hydrostatic Sensor Installation <br />5. Install the cord grip from the Sensor install lit into the field junction box. Push the sensor cable into the <br />junction box through the cord grip. Using the wire nuts from the Sensor install kit, connect the sensor cable <br />to the console cable as shown in Figure 3. Tighten the cord grip. <br />6. Seal wire nuts with epoxy sealant following the instructions in Figure 4. <br />�zazo <br />CAUTION: Epoxy sealant is irritating to eyes, respiratory system, and skin. Can rause allergic skin reaction. <br />Contains: epoxy resin and Cycloaliphatic epoxycarboxylate. Precautions: Wear suitable protective clothing, <br />gloves, eye, and face protection. Use only in well ventilated areas. Wash thoroughly before eating, drinking, <br />or smoking. <br />To i i 1 ti Black <br />Interstitial <br />Sensor i i Seal -off i i From <br />Interface ' ' Sensor <br />Module i ® white <br />�t/2' ngid�v <br />conduit <br />Epoxy sealed connections in a <br />weatherproof junction box <br />n <br />Figure 3. Sensor Field Wiring Diagram <br />1-1 <br />Instructions: <br />NOTE: When temperature is below 50'F (10'C), <br />keep resin in a warm place prior to mixing (e.g., <br />in an inside pocket next to body). <br />1. Open epoxy sealant package, and remove resin <br />pak. <br />2. Holding resin pak as shown in A, bend pak along <br />long length. <br />3. As shown in B, firmly squeeze the RED SIDE of <br />the resin, forcing it through the center seal and <br />Into BLACK SIDE. <br />From probe, <br />sensor, or <br />transducer To console <br />Make sure that <br />the ends of cable <br />sheathing are sub- r ►� <br />merged in sealant Tie wrap <br />Wire nuts <br />4. Mix thoroughly to a uniform color by squeezing <br />contents back and forth 25-30 times. <br />5. Squeeze mixed, warm resin into one end of bag <br />and cutoff other end. <br />6. Slowly insert wiring connections Into sealing <br />pack until they fit snugly against the opposite <br />end as shown In C. <br />7. Twist open end of bag and use tie wrap to close <br />it off and position the tie wrapped end up until <br />the resin jells. <br />Figure 4. Epoxy Sealing Sensor Field Connections <br />7. Push the epoxy sealed bag into the junction box. Replace and tighten the junction box cover. <br />