Laserfiche WebLink
r <br /> Site Address: SS#2133,2908 Benjami olt Drive,Stockton Da Pof Testing/Servicing: Z=� .3 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: <br /> Co lete the following checklist: <br /> s ❑ No* Is the audible alarm operational? <br /> s ❑ No* Is the visual alarm operational? <br /> s E] No* Were all sensors visuallyinspected,f inctionall tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes Cj Nd* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> /N/A operational? <br /> 04Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails too e_r�ate�is electrically disconne d? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ER Sump/Trench Sensors; ispenser Co mment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? es; ❑No. <br /> ❑ YesEZ/A <br /> For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at1-1 the tank <br /> fill poings)and operating ro rl ? If so,at what percent of tank capacity does the alarm trigger? ????% <br /> LYeo Was any monitoring equipment replaced? If yes, identify specific sensors,probes,or other equipment replaced <br /> and list the manufacturer name and model for all replacement arts in Section E,below. <br /> o Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) D <br /> Product; ❑Water. If es,describe causes in Section E,below. <br /> ❑ No* Was monitorin s stem set-u reviewed to ensure ro er settin s? <br /> ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: 2yAeDCL POTS i'3o7"11 apvr 7gy3ed-Za'9 s rvSo 2 s. <br /> Page 2 of 3 03/01 <br />