Laserfiche WebLink
Publication No.: DXPI200 <br /> Effective Date: 09-17-95 <br /> S EIR I NE bAft D I NS mr Em N S stm R UMN Supersedes: NEW <br /> U00% aamms <br /> IN055hUALLATION2 IN!"i"INGTIUN <br /> mill <br /> GENERAL ASSEMBLY <br /> Step Two <br /> h Mount stabilizer bar into <br /> r_ unistruts. <br /> .� <br /> � Step Three <br /> Imp® — Attach the shear valve <br /> Pan installation requires the use of boss-mount shear <br /> a bracket to the stabilizer bar <br /> valves and 1-1/2"male flex connectors.Total using the hardware provided. <br /> Containment Flex Jackets can be used to isolate flex Adjust the height of the <br /> connectors in this application. bracket so that the shear <br /> section of the shear valve is <br /> even with the top of the <br /> PRE-INSRLLMON frame. <br /> Step one—Installing Was <br /> Before installing dispenser <br /> pan,layout and measure for For Presssure and Suction Systems <br /> -� appropriate drill locations. [Anchoring) <br /> Refer to dispenser footprint Step One_ <br /> for location of product, <br /> vapor,and conduit entries. Put dispenser anchor bolts <br /> through holes located on <br /> For further directions,please refer to the Bulkhead frame.Be sure threaded part <br /> Fitting Installation Instructions BFI726,that are <br /> _ g � is above frame as shown in <br /> supplied with the bulkhead fittings. photograph.Put a washer <br /> ® ` ; and a nut above and below <br /> Step T —Installing Pan Boot the frame.Adjust the frame <br /> Install`pan entry boot as per anchor bolts to point <br /> instructions on the template downwards as illustrated in <br /> 4' providedwith the pan entry the photograph. <br /> i boot. Refer to dispenser <br /> ® manufacturer for <br /> recommended anchoring <br /> \, instructions. <br /> wA. <br /> / <br /> For Pressure Svstems <br /> Step One �quesln � the <br /> Install shear valve mountingIfila�1 511& <br /> .� plate to boss of shear valvean °�tSt4t11@I <br /> using the three fasteners �gy� � 77. <br /> / <br /> provided. y <br />