Laserfiche WebLink
D. Results of TestingMervicing <br />Software Version Installed: <br />® Yes <br />❑ No" <br />Is the audible alarm operational? <br />® Yes <br />❑ NW <br />Is the visual alarm operational? <br />IE Yes <br />❑ No" <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑ No' <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br />operation? <br />❑ Yes <br />❑ No' <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) operational? <br />® N/A <br />® Yes <br />❑ No" <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system deter a leak, <br />❑ NIA <br />fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check aN that apply) ® SumpfTrench <br />Sensors; ❑ Dispenser Containment Sensors. <br />Did you Confirm positive shut -down due to leaks= sensor failure/d'isconnection? ® Yes; ❑ No. <br />❑ Yes <br />❑ No' <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br />® N/A <br />installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity <br />does the alarm trigger? 00/6 <br />❑ <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name <br />and model for all replacement parts in Section E. below. <br />Yes <br />❑ <br />® No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />❑ Product; ❑ Water. if yes, describe causes in Section E, below. <br />Yes <br />® Yes <br />❑ No' <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />® Yes <br />❑ No' <br />I Is all monitoring equipment operational per manufacturer's specifications? <br />' In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. comments: 87 SENSOR IN STP SUMP WOULD NOT SHUTDOWN WHEN IN ALARM <br />NEEDS TO BE FIXED OR HAVE A LINE TEST DONE <br />r <br />Monitoring System Certification Page 2 of 4 <br />2/21/07 <br />9T00/OT00[n 9TTO tVL 60Z XVJ U :TT 60OZ/ZO/TT <br />