Laserfiche WebLink
t a -If :_ <br />JoaquinSan <br />Environmental Department <br />March 12, 2009 <br />Allen Thomas <br />Dresser Inc. <br />2519 Evergreen Ave <br />.1i <br />&10tVVAff",AT7k"Aq75TX-7= <br />Phone:1 •) 468-3420 <br />1• 464-0138 <br />West Sacramento, CA 95691 <br />Fax: (916) 372-9376 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent by Fax and Mail <br />Hammer Lane 76,3202 W Hammer Lane, Stockton (S0056730) <br />The San Joaquin County Environmental Health Department (EHD) has completed the <br />review of the permit application to install/repair Bravo under dispenser containment <br />(UDC) floats and chains on the #5 and #7 dispensers at the above noted address. The <br />permit has been approved with the following conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution <br />Control District for any applicable permits and requirements. <br />2. Contact Garrett Backus to arrange the following inspections (a 48 hour <br />notice is required): Functionality test of the Bravo floats and chains of <br />dispensers 5/6 and 7/8. <br />3. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all <br />of the following: <br />a. One of several permissible valid, current contractor's licenses issued by <br />the Contractors State License Board (may be issued to the installation <br />company), and <br />b. A valid, current California UST Service Technician certificate issued by <br />the International Code Council (ICC), and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced, and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />4. Permit expires 180 days from date of approval. Note: If an extension to the <br />expiration date is required, a written request must be submitted to this office prior <br />to the expiration date. <br />5. All components must be certified by an independent testing organization and <br />labeled as required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See <br />Page 1 of 2 <br />