Laserfiche WebLink
7i] <br />Eil <br />6. Verify that the water level will not cover electrical threaded connections before water <br />testing. If the water will exceed threaded connections to the dispenser conduit seal -off one <br />must ensure no water will enter through that point. This assumes that the conduit threaded <br />connections are not liquid tight. Visual testing only allowed on initial installation to pass <br />NO drips leaks are allowed. If outside of sump can not be observed a minimum 5 hour test <br />must be observe with a level drop no greater than 1/8". Alternative testing can be used such <br />as electronic level probe, which can use its accuracy to reduce test time. <br />7. E.g Data collection time Typical 12" x 32" Box and fail rate of .05 GPH <br />Failure, if rate exceeds Resolution/accuracy Data Time <br />0.0030 in 6 minutes Better than .0005" 6 minutes <br />0.0070 in 15 minutes .001 to .002" 15 minutes <br />0.0150 in 30 minutes .002 to .003" 30 minutes <br />8. After the completion of the water test, certify if the test has passed based on the schedule <br />above. If you experience problems contact Bravo for assistance (323) 888-4133. <br />9. Remove water and properly dispose of and manually dry float cup area. Next, remove <br />weight off the float, if applicable, and make sure the chain is properly adjusted as indicated <br />on installation maintenance instructions. This includes verification of float trip function and <br />proper lead seal crimping to prevent future tampering. To adjust chain, refer to Bravo <br />Installation Instructions page 7 of B2000 Shallow Box and page 6 of the B-8000 Deep Box. <br />10. NOTE: If Local Jurisdictions have high requirements than these please use their test <br />protocols. <br />Thank You, <br />Don Mukai P.E. <br />Bravo Engineering <br />f:Aengineering\winwordyDocumentOut\Doc01-06.doc <br />