Laserfiche WebLink
March 7, 2008 <br />0 <br />San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />Salle Elliot <br />Elite IV Contractor Inc. <br />2535 Wigwam Drive <br />Stockton, CA 95205 <br />Fax: (209) 461-6342 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />Stockton, California 95202-3029 <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Website: www.sjgov.org/ehd <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Phone: (209) 468-3420 <br />Robert McClellon, REHS <br />Fax: (209) 464-0138 <br />.teff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent by Fax and Mail <br />RE: Kayo Oil, 3202 W Hammer Lane, Stockton (SR0053533) <br />The San Joaquin County Environmental Health Department (EHD) has completed the <br />review of the permit application to install/repair Bravo under dispenser containment <br />(UDC) floats and chains on the #5 and #7 dispensers at the above noted address. The <br />permit has been approved with the following conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution <br />Control District for any applicable permits and requirements. <br />2. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all <br />of the following: <br />a. One of several permissible valid, current contractor's licenses issued by <br />the Contractors State License Board (may be issued to the installation <br />company), and <br />b. A valid, current California UST Service Technician certificate issued by <br />the International Code Council (ICC), and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced, and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />3. Permit expires 180 days from date of approval. Note: If an extension to the <br />expiration date is required, a written request must be submitted to this office prior <br />to the expiration date. <br />4. All components must be certified by an independent testing organization and <br />labeled as required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See <br />California Code of Regulations (CCR), Title 23 Chapter 16 Table B for complete <br />list). The component must bear the appropriate mark as required by the <br />independent testing organization. <br />Page 1 of 2 <br />