COMPLIANCE INFO_1995-1999 - Laserfiche WebLink

Home Browse Search

M 7� t-lexlote miry 000t:s These rubber boots are designed to seat pipe and conduit entries for boat The recommended size tote saw size must correspond with the Flexible Entry underground and above ground applications. For proper installation. the Boot size. appropriate size taoncation ternolate should be used for accurate rote drilling. _ Step #1 falcate the center entry point in the flat wall section of me sump case and drill a 5116' hole. Install the Entry Boor 7emptate to the sump oase wall using a 1/4' bolt and nut. Drill out the appropriate bolt hole circle for the size boot to be instaned usinc the same 5/16' drill bit. After drilling remove the template from me sump base wall. Step #3 Install the rubber boot from outside the sump by inserting the studs through the bolt toles. From the inside of the sump. install the com- pression ring over the studs and install nuts by hand. Step #5 Insert the appropriate sized pipe or conduit into the flexible toot from out - sloe of the sump. After the pipe or conouit has been positioned. install the band damp around the boot and tighten to 30 in. lbs. Fastener Entry Boot Template Round Surface installations Flexible Entry Boots may be instafted on round surfaces which nave a radius diame- ter greater than 30'. The installation pro- ceoutres are the same as described above except the 5/16' bolt toles should be made slightly larger after initial drilling. This can be accomplished by moving the 5/16' bit from side to side in each loft hole after the Entry Boot Template has been removed. This will enable ate entry boot stuas to move slightly inward when tightening down the nut fasteners. Tighten down eac n nut it stages so the boa flange and compres. sion ring can evenly conform to ate round- ed surface. Band Clamp Step #2 After the bolt tole ciM. a nas been drilled. drill the entry boo: aoening by using the appropriate size note saw. Atter opening is drilled. clean any rough edges with a razor Knife. Hole Saw Flexible Entry Boots 2.38' FES -3050.3-M. 3075.3100 a.114- FES.6150. F_3 GFS -6M0 .:11,14- FES -6300.6350 5.17 FES -7, 3W, 7W 5.112' SAB -7400. GOB -7450 Sage saw F Step #4 Using a 7116' rut driver. achten all of the nuts evenly and firmty. To prevent deforming boots co not over tighten num. If a tomue wrench is used. me setting should oe 60 in. lbs. Angled Entries The flexible entry boot is flexible enough to permit angled pipe or con- duit entries up m 30- anote (15- in each direction). Angles greater than 30- could prevent the boot trom seal- ing around the pipe or conduit.