COMPLIANCE INFO_1995-1999 - Laserfiche WebLink

Home Browse Search

4. Measure the distance from the tank top P(inside) to the top of the standpipe. Subtract 1 inch from this measurement and record the distance. 5. Subtract the second distance from the first and record this value as reading "S" on the Installation Checklist. 1. Subtract reading '8' from reading "A". 2. Compare this value to the table of Maximum Allowable Deflections shown on the Installation Checklist. 3. Vertical deflection in excess of these values indicates improper installation and voids the tank warranty. SINGLE WALL TANKS Single wail tank installations may require release detection monitoring, which can include inventory control, automatic tank gauging, vapor monitoring or ground water monitoring. Check with federal, state, and local officials for requirements in your area. a Xerxes double wall tank has an interstitial space for the containment of leaked product from the primary tank. The tank, as supplied, will have a minimum of one monitor fitting that provides access into the space between the primary (internal) and secondary (external) tank walls. if a double wall tank is sloped, the monitor should be at the low end. The monitoring system and method is the responsibility of the tank owner and/or operator. A safe electronic or mechanical system should be used to detect either incoming water or product. The monitor system should detect leakage near the bottom of the tank. Monitoring can be done through the monitor fitting provided. If the tank is sloped, the lowest elevation must be the monitoring end. WITH LIQUID -FILLED INTERSTITIAL SPACE In a liquid -filled monitoring system, the interstitial spam is filled with liquid at the point of manufacture. The system enables the owner to have continous monitoring or to conduct a tank tightness test (Tru CheciM. It also provides the ability to use an electronic reservoir monitoring system. Additional Xerxes tanks can be installed at emoting locations if proper foundation support exists. The method of installation is the responsibility of the owner. Itis required, however, that one of the following methods be used. The preferred method is to install a new tank in a seoarate hole at least 3 feet from the original hole. Caution must be exercised in keeping unusual surface loads off existing tanks. The natural barrier of undisturoed soil between tanks must be maintained. FIGURE 15-1 If this method is not practical, additional tanks may be buried in the same installation hole. After emptying existing tanks to less than one-quarter capacity, remove the surface slab. Enlarge the excavation for the new tank, leaving as much backfill as possible around existing tanks. It may be necessary to install shoring to make sure that existing tanks do not move and that sufficient backfill remains. The new tank must be installed by following the procedures in this guide. Remember to leave a minimum of 18 inches between tanks. The backfill material must be the same as that specified in Section 3. FIGURE 15-2