Laserfiche WebLink
This manual contains installation procedures for the Veeder-Root Piping Sump Sensor(Part No. <br /> 794380-208 or 794380-209),in any of the following Veeder-Root monitoring systems: <br /> • TLS-300 Consoles <br /> • ILS-350 Console <br /> • TLS-350 Series Consoles <br /> Related Manuals <br /> Depending on your installed console,you must reference the appropriate manual below for field wiring <br /> requirements and sensor-to-console connections: <br /> 576013-879 TLS-300/TLS-350 Series Consoles Site Prep and Installation Manual <br /> 576013-773 ILS-350 Console Site Prep and Installation Guide <br /> Contractor Certification Requirements <br /> Veeder-Root requires the following minimum training certifications for contractors who will install and <br /> setup the equipment discussed in this manual: <br /> Levet 1 Contractors holding valid Level 1 Certification are approved to perform wiring and <br /> conduit routing,equipment mounting,probe and sensor installation,tank and line <br /> preparation,and line leak detector installation. <br /> Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation <br /> checkout,startup,programming and operations training,troubleshooting and servicing <br /> for all Veeder-Root Tank Monitoring Systems,including Line Leak Detection and <br /> associated accessories. <br /> Warranty Registrations may only be submitted by selected Distributors. <br /> Safety Symbols <br /> The following safety symbols may be used throughout this manual to alert you to important safety <br /> hazards and precautions <br /> Explosive Flammable <br /> Fuels and their vapors are extremely Fuels and their vapors are extremely <br /> explosive if ignited. flammable. <br /> 1 <br />