COMPLIANCE INFO_2007-2009 - Laserfiche WebLink

Home Browse Search

• , ,4 f Using wire nuts,connect the two-wire cable to the field wires in the sensor junction box(see Figure 2). ® Black To Interstitial From Sensor i Seal-off 1 Sensor Interface i i i i Red Module _*'�'1/2"rigid�� } conduit I Epoxy sealed connections in a weatherproof junction box Figure 2.Sensor Field Wiring Diagram ® Epoxy sealant may be irritating to skin and eyes,absorbed through the skin, or cause skin sensitization in susceptible individuals. Minor injury may result.Also materials contained in epoxy have caused skin cancer in animal tests. Avoid skin and eye contact.Wear appropriate safety equipment.Use only in well ventilated areas. Seal wire nuts with epoxy sealant using one bag for two wire nut connections.Ensure the epoxy covers the end of the outer cable jacket.To prepare epoxy and seal connections: 1.Alternately squeeze each end of packet until wall between two chambers breaks,allowing contents to mix. Continue to knead packet until color is uniform and contents are completely blended. 2.Cut one end of packet.Insert wire nuts and wires into packet[Figure 3]. lmportantM' You must seal the wire nuts or warranty will be void! If more than two wire nut connections share an ep- oxy sealant bag,the connections will not be properly sealed.Improper sealing of the connections may re- sult in inaccurate system readings and false alarm conditions. 3.Tie open end of packet with tie wrap. Using thumbs and forefingers as shown, When mixture becomes well blended and bend epoxy sealant package back and warm, cut off one end of package and forth until seal between compound insert the wire nuts and wires down into sections has broken.Then using fingers the sealant mixture. Use tie wrap to close squeeze package to mix sealant. up package around wires. To sensor To console Make sure that end of cable jacket /Tie wrap is submerged ,f in sealant. Wire nuts Figure 3.Epoxy Sealant for Two-Wire Connections 6