Laserfiche WebLink
D. Results of T'esting/Serviein g <br /> r <br /> Software Version Installed: 3, 6 c) <br /> Complete the following checklist: <br /> Yes ❑ No* Is the audible alarm operational? <br /> Yes ❑ No* Is the visual alarm operational? <br /> Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Yes LlNo* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes L3No* If alarms are relayed to a remote monitoring station, is all communications equtlment (e.g. modem) <br /> N/A operational? <br /> Yes ElNo* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate,or is electrically disconnected? If yes:which sensors initiate <br /> positive shut-down? (Check all that apply) A Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? Yes; ❑No. <br /> ❑ Yes ❑ .No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> 93 N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> Lesfill point(s)and o eratin properly? If so,at what percent of tank c2pacity does the alarm trigger? <br /> s* Ld No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced <br /> and list the manufacturer name and model for all replacement arts in Section E,below. <br /> s* ids No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑Water. If es,describe causes in Section E,below. <br /> s ❑ No* Was monitoringsystem set-u reviewed to ensure proper settin s?Attach set u reports,if applicable <br /> ❑ No* I Is all monitorin a ui ment 2perational per manufacturer's specifications? <br /> *In Section:E below;describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> S <br /> Page 2 of 3 03/01 <br />