Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: <br />Cowl)lete the following checklist: <br />Yes <br />❑ No* <br />Is the audible alarm operational? <br />❑ No* <br />Is the visual alarm operational? <br />es <br />❑ No* <br />Were all sensors visually ed, functionall tested, and confirmed operational? <br />Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment <br />will not interfere with their ploar operation? <br />Y <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />❑ N/A <br />operational? <br />Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) E,143ump/Trench Sensors;nser Containment Sensors. <br />Did you confirm sitive shut -down due to leaks and sensor failure/disconn on? ,Yes; ❑ No. <br />Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑ N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br />fillmi t(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? <br />Q % <br />❑ Yes* <br />N <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment <br />replaced and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Y <br />No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />❑ Product; ❑ Water. If yes, describe causes in Section E, below. <br />es <br />❑ No* <br />Was monitoring m set-up reviewed to ensure proper settings? Attach set up E22rts, if applicable <br />if Yes <br />❑ No* <br />Is all monitorin went o rational Mr manufacturer's cations? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Testing Company Name:1 /TANK <br />I-TEK ENVIRONMENTAL/ CORPORATION Phone No.: (707) 446-6151 <br />Site Address: ��®� i�l°L�Q. (/� l�yL�X Date of Testing/Servicing: 10/2505 <br />Page 2 of 3 03/01 <br />