Laserfiche WebLink
D. Results of Testing/Servicing <br /> Software Version Installed: T CoQo <br /> Complete the followin q'hecklist: <br /> RL Yes ❑ No* Is the audible alarm o erational? <br /> Yes ❑ No* Is e visual alarm operational? <br /> Yes ❑ No* Were all sensors visually inspected,functional!y tested,and confirmed operational? <br /> t, Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> notinterfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> ®. N/A operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) 99 Sump/Trench Sensors; 911-Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? A Yes; ❑No. <br /> Cj Yes ® No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill jpoint(s2 and op=tinro erl ? If so,at what percent of;tank capacity does the alarm tri er? % <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement, arts in Section E,below. <br /> ❑ Yes* M No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑ Water. If yes, describe causes in Section E,below. <br /> Yes ❑ No* Was monitoring system set-up reviewed to ensure Proper settings?Attach set up reports, if applicable <br /> 3k Yes. ❑ No* Is all monitoring a ui mentoperational per,manufacturer's s ecifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 03/01 <br />