Laserfiche WebLink
A clear plastic cover is provided for safety and protection. This cover should be removed when <br />wiring the master relay and the input power terminals. Remove the two screws that secure the <br />housing to the base plate and carefully lift out the cover. All wiring on and to the input power ter- <br />minal block must comply with local codea, enter and exit through the conduit hole provided. <br />After the completion of the wiring replace the cover and reinstall the two mounting screws. <br />The Leak Alert system has provide a set ofGPIDTmaster relay contacts. These are for <br />applications such as a remote alarm, automatic telephone dialer, or product pump shut down <br />control, etc. This master relay iomounted onthe mother board and itioactivated byany alarm <br />signal from any ofthe individual monitoring channels. Connections forthemaster relay contacts <br />are located on the Input Power Terminal Block found at the bottom of the enclosure. Refer to <br />Sec. //./.8Pg 2. The relay connections are marked COM forthe arms of the relay, NO forthe nor- <br />malopencontoct.aodWOforthenormm|o|oamdcontoot.There|oynontaotoareo*ted5Amps. <br />115 VAC. <br />The Leak Alert system operates from astandard single phase 11SVAC 5O/G0HZpower <br />source. Input power wiring is accomplished by three terminals located on the Input Power Ter- <br />minalB|oohfoundedthebottomoftheeno|oouna.RehprtoSeo//.1B'K8arkingsforthetermine|a <br />are LINE for connection of the input power line wire, NEUTfor the neutral wire, and GRD for the <br />ground wire. All wiring should complywith local electrical codes.Afuse rated at2Amps. 115VAC <br />is provided for circuit protection. <br />Refer to Section /1.4, INTERNAL ELECTRICAL WIRING Page /4 for wiring schematic. <br />W <br />