Laserfiche WebLink
safety warnings <br />This device is installed in equipment where potentially lethal v <br />exist and where product spillage could create serious environmmeeantaall and <br />may <br />® safety hazards - <br />The following hazards exist: or death may result if power is <br />1. Electrical shock resulting in senous injury installed. <br />on during installation and the device is improperly a or explosion <br />could cause severe environmental damage <br />equipment <br />2- Product leakage Personal injury, property <br />resulting in death, serious pe <br />damage, <br />Observe the following precautions: <br />1. Read and follow all instructions in this -manual, including all safety <br />warnings- the National Electrical Code; <br />1 with all applicable codes including: Bitable safety codes. <br />2. Comp Y <br />s federal, state, and local codes, and otherwer to the system, including <br />3. Before installing this device, turn off p <br />console and submersible PUMPS. <br />struck by vehicles, block off <br />4. To protect yourself andothersslion orfrom service. <br />your work area during <br />5. Substitution of components may impair intrinsic safety. <br />Field wiring Requirements <br />sole's latest Site Prep manual for required wiring type, gauge, length, etc., needed for <br />You oiw consult your con <br />for field wiring the console to the sensor. <br />Installing Sensor <br />1. Turn OFF power to the console. Important! Do not install the sensor if there is <br />2. Make sure liquid is present in the sump's interstial liquid reserviorto an alarm. . <br />less than 0.8" of liquid in the reservoir. Failure to'comply <br />til t sitsoir tlondthe bottom of the reservoir as een sump <br />in the <br />in Figure 1. Note: the actual reservoir and location will vary betty <br />3. Lower the float switch assembly into the reservoir <br />installation example9 ary between <br />manufacturers. <br />lid. Route and tie <br />The sensor housing should not be suspended by the cabble being le. <br />Da ed When replacing the sumpAe than lid. <br />the sensor and junction box to avoid excess <br />basump component installation or maintenance. <br />off the cable so that it can not be damagedY <br />4 <br />