Laserfiche WebLink
D. kesults of Testing/Servicin <br />Software Version Installed: 15.01 <br />Complete the following checklist: <br />n <br />L] Yes <br />❑ No* <br />Is the audible alarm operational? <br />Yes <br />No* <br />Is the Visual alarm operational? <br />x Yes <br />gxx <br />No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />Yes <br />❑ No* <br />Were all sensors installed at the lowest point of secondary containment and positioned so that other <br />equipment will not interfere with their proper operation? <br />Yes <br />No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />HxN/A <br />operational? <br />x Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary <br />❑ N/A <br />containment monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: <br />which sensors initate positive shut -down? ❑ Sump/Trench Sensors [x]Dispenser Containment Sensors <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnected? L] Yes; ❑ No; <br />❑ Yes <br />® No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />Fx ] N/A <br />mechanical overfill prevention valve is installed), is the overfill warning alarm visual and audible at <br />the tank fill point(s) and operating properly? If so, at what percent of tank capasity does the alarm <br />trigger? E= % <br />❑ Yes* <br />❑ No <br />Was any monitoring equipment replaced? If Yes, identify specific sensors, probes, or other equipment <br />replaced and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />❑ No <br />Was liquid found inside any secondary containment systems designed as dry systems? <br />Product; ❑ Water. If yes, describe causes in Section E, below. <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set-up reports, if applicable. <br />Kt] <br />No* <br />Is all monitoring equipment operational per manufacturer's specifications? 11 <br />* In Section E below, discribe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />