Laserfiche WebLink
Monitoring System Certification-Pa 0 <br /> of 3 <br /> Site Address: 341 E.Main,Ripon Date of Testing/Servicing: 4/5/01 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: <br /> Complete the follo ing checklist: <br /> ❑x Yes ❑ No* Is the audible alarm operational? <br /> El Yes ❑ No* Is the visual alarm operational? <br /> 91 Yes ❑ No* Were all sensors visually inspected,finictionally tested,and confirmed operational? <br /> 21 Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑x Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> ❑ N/A operational? <br /> ® Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) x Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? x Yes; ❑No. <br /> ❑ Yes ❑ No*N/A For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> CHI mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and operating If so,at what percent of tank capacity does the alarm trigger? % <br /> Ll Yes* ® No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yes* ❑x No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑Water. If yes,describe causes in Section E,below. <br /> E Yes L3No* Was monitoring system set-up reviewed to ensure proper settings? Attach set-up reports, if applicable) <br /> ® Yes ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> UN-036-3/6 http://www.unidocs.org Rev.08/22/00 <br />