Laserfiche WebLink
Franklin Fueling Systems Tech www.f ra n k l i n f u e l i n a.corn <br /> --� Service <br /> �v1 B u Iletin <br /> P.O. BOX 638 SACO, ME 04072 USA 0001134 Rev.B, <br /> Sensor Splice Kit — Installation Instructions <br /> Please read these instructions carefully and refer to Figure 1 below. The new Sensor Splice Kit <br /> includes 3 Electrical Connectors for installation inside the manhole Junction Box Only. It is not <br /> intended for direct burial applications. <br /> r - - - - --� <br /> CAUTION Failure to use the splice ! SIM I (After wiring) <br /> kit will void the warranty. ! Conne for <br /> i Splice Kit I <br /> NOTE# For a spare supply of (Before # <br /> moisture-resistant splice I wiring) <br /> connectors, Order: <br /> for ac of 0 splices. - (RED) PNMT) (BLK) <br /> PWR GND <br /> For Direct Burial Cable <br /> Applications or for Applications <br /> thatdon't use a Junction Box, <br /> order. TO <br /> SENSOR <br /> TSP-DB1 for a single kit, or TSP- <br /> DB10 for 10 kits (see cross section at ( For 3 wire <br /> right). I I I sensors only <br /> H I r <br /> TO CONSOLE <br /> Figure 1 Electrical Connector Splice Kit—Sensor Wiring <br /> 1.) Use 2 or 3 moisture-resistant connectors (provided) for each sensor installation. <br /> 2.) Insert 2 red unstripped wires into two separate openings of the first connector. <br /> li This step is only required with 3 wire sensors. <br /> 3.) Insert 2 white unstripped wires into two separate openings of the second <br /> connector.* <br /> 4.) Insert 2 black unstripped wires into two separate openings of the third connector. <br /> NOTE For steps 2, 3, and 4, ensure that the wires are fully inserted and seated at the <br /> end of the connector(look at the translucent connector body to verify this). Use <br /> 8" slip joint pliers and squeeze each connector together (position the pliers on <br /> the connector perpendicular to the wires and drive the black cap down almost <br /> flush to the edge of the connector body). <br /> — mss° — <br /> E-mail: tech@franklinfueling.com FAX 1-207-282-9002 TEL 1-800-984-6266 PAGE 1 of 1 <br /> sales(a)franklinfueling com FAX 1-207-283-0158 TEL 1-800-872-3455 <br />