Laserfiche WebLink
0 0 environ <br />19 Other Miscellaneous Seals <br />Conduit Entry Boot <br />Patent Granted <br />Other Patents Pending <br />A studded entry boot is used to seal 3/4" conduit entries into the <br />bottom of a Shallow Dispenser Pan. Their small size allows them <br />to be used in congested areas in the bottom of a dispenser pan <br />and to allow close perimeter conduit entries. <br />NOTE: Conduit entry boots are permitted in the bottom of dispenser <br />pans only. For conduit penetrations in sumps, use the appropriate <br />sized flexible entry boot through the side wall of the sump only. <br />CEB-3075 ' 3/4" <br />19 M AM M1 • • <br />A rubber isolation tube designed to provide dielectric isolation of <br />a metal flex connector entering the base of a Shallow Dispenser <br />Pan. The flexible tube attaches at its lower end to the outside of a <br />3" nominal pipe and at its upper end to the studded cuff section of <br />a Pipe Entry Boot or Stage II Entry Boot. The Flexible Isolation Tube <br />is not intended for secondary containment <br />FIT -3530 3-1/2" X 30" <br />FIT -3542 3-1/2" X 42" <br />An optional rubber donut used to permit the Flexible Isolation <br />Tubes to seal onto pipe diameters smaller than a 3" nominal pipe. <br />This reducer donut is used in Shallow Dispenser Pan applications <br />only. <br />ITR -3015 3" OD x 1-1/2" ID Seals 1-1/2" Rigid Pipe <br />ITR -3020 3" OD x 2" ID Seals 2" Rigid Pipe <br />Rubber Reducers <br />]~@ <br />P*1 A <br />