COMPLIANCE INFO_2011-2016 - Laserfiche WebLink

Home Browse Search

MONITSRING SYSTEM CERTI ATI -, CERTIFICATION /TEST DATE: February 18, 2014 FEB 2 8 2014 A1. FACILITY A2. OWNER Name Olympian # 427 Name Flyers Energy LLC. HEALTH DEPARTMENT Address 3300 Waterloo Road, Stockton, CA 95205 Address 2360 Lindbergh Street, Auburn, CA 95602 Phone # 530-885-0401 Phone # 530-885-0401 Contact Amanda Appelt contact Amanda Appelt D. RESULTS OF TESTING / SERVICING Make / Model of Monitoring System: Veeder-Root TLS -350 SN# Software Version Installed: 329.01 Complete the following checklist: ■ Yes ❑ No* is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment ■ Yes ❑ No* will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, Is all communications equipment (e.g. modems) ■ N/A ❑ No* operational? For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ■ Yes ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ❑ Dispenser Containment Sensors. ■ Yes ❑ No* ❑ No. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no ❑ Yes ■ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank ■ No fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? _ % ❑ Yes * Was any monitoring equipment replaced? If yes, Identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ❑ Yes * ■ No Was any liquid found Inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ❑ Water. If yes, describe causes in Section E, below. ■ Yes ❑ No* Was monitoring system set-up reviewed to insure proper settings? Attach set-up reports, if applicable. ■ Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? In Section E below, describe how and when these deficiencies were or will be corrected. E. COMMENTS Unable to test the Red Diesel STP sump sensor for positive shutdown, sensor out, or fail-safe. Page 2 of 3