Laserfiche WebLink
1 <br /> Monitoring System Certification <br /> Site Address: 124 W.ELM STREET,LODI Date of Testing/Servicing: 8/16/01 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: N/A <br /> Complete the foll ing checklist: <br /> ® Yes ❑ No* Is the audible alarmoperational? <br /> ® Yes ❑ No* Is the visual alarmoperational? <br /> ® Yes D No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment <br /> will not interfere with their proper operation? <br /> ® Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> ❑ N/A operational? <br /> p Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> S N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors <br /> initiate positive shut-down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment <br /> Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑Yes; p No. <br /> ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> S N/A mechanical overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank <br /> fill pints and operating properly? If so,at what percent of tank mpacity does the alarm trigger? ????% <br /> ❑ Yes* S No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment <br /> replaced and list the manufacturer name and model for all r lacement parts in Section E,below. <br /> ❑ Yes* S No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> D Product; ❑Water. If yes,describe causes in Section E,below. <br /> S Yes ❑ No* Was monitoring s em set-up reviewed to ensure proper settings? <br /> S Yes ❑ No* I Is all monitoring equipment operational per manufacturer's edfications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 03/01 <br />