COMPLIANCE INFO_2005-2008 - Laserfiche WebLink

Home Browse Search

• Facility: Tracy BP Service Center D. Results of Testing/Servicing Software Version Installed:Not Noted Complete the following checklist: ®Yes ❑ No* Is the audible alarm operational? ❑Outside Audible Alarm? ®Yes ❑ No* Is the visual alarm operational? ®Yes ❑ No* Is the print function operational? ❑Not installed. ®Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? ®Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) ® N/A operational? ®Yes ❑ No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) ®Sump Sensors; ®Dispenser Containment Sensors. Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ®Yes; ❑No. ❑Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s and operating ro erl ? If so,at what percent of tank capacity does the alarm trigger? ❑Yes* ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E,below. ❑Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑Product; ❑Water. If yes,describe causes in Section E,below. ®Yes ❑ No* Was monitoring stem set-up reviewed to ensure proper settings?Attach set up reports,if applicable ®Yes I ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? *In Section E below,describe how and when these deficiencies were or will be corrected. E. Comments: When we tested the 91 Octane fillspill bucket it failed to hold water. It appears that there is a leak where the flexible bellows attaches to the steel bottom of the bucket. Elite IV was called out to make the repair. The bucket must be replaced within seven days and a tank precision test performed within seven days after the repair is completed. Page 2 of 3 03101