Laserfiche WebLink
D. Results of Testing/Servicin <br />Software Version Installed: <br />Complete the following checklist: <br />Ye <br />❑ No* Is the audible alarm operational? <br />Yes <br />❑ No* Is the visual alarm operational? <br />Yes <br />❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br />❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />Yes <br />not interfere with their proper operation? <br />Cl Yes <br />❑ N * If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />N/A operational? <br />❑ Yes <br />❑ N * For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br />❑ *—.For For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑ Yes <br />N/A mechanical overfill prevent valve is installed), is the overfill warning _alarm visible and audible at the tank <br />CT�fill <br />point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? <br />❑ Yes* <br />No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* <br />No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that appl)) <br />❑ Product, ❑ Water. If yes, describe causes. in Section E, below. <br />Ye <br />❑ No* Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />Yes <br />❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these aeimencies were o n„[ U� • 61 <br />E. Comments: <br />