Laserfiche WebLink
- • ' • •SensorAppliflon Guide <br />Sumba Sensor <br />The sensor is installed in a tank piping sump and will detect the presence of a liquid. Liquid level is monitored by a <br />float /magnetic reed switch sensing system. <br />Sensor Detection Capabilities - Alarm Conditions <br />• Fuel alarm is triggered when liquid reaches a nominal height of 1 -inch. <br />• An open sensor triggers a Sensor Out alarm. RECENI"]ED <br />Operating Capabilities <br />• Operating temperature range: 0 to +60°C. N O V 2 6 1.014 <br />• Storage temperature range: -40 to +70°C. <br />• Sensor dimensions: 12" high, 1.9" diameter. ENVI I' HEALTH <br />Sensor/Cable Length Configurations Fri IN: <br />• Sump Sensor w/ 12 foot cable - Form Number 794380-208 <br />• Sump Sensor w/ 30 foot cable - Form Number 794380-209 <br />• TLS -350 Series Consoles (except TLS -350J) - Interstitial/Liquid Sensor Interface Module (P/N 329358-001) <br />accepts up to 8 sensors (a maximum of 64 sensors could be monitored by the console). <br />• TLS -350J Console - 3 sensors max. <br />• TLS-300/PC-300 Series Consoles (no Interface Module required) - 8 sensors max. <br />• ILS -350 Console - A Two -Wire Module (P/N 329675-001) accepts up to 4 sensors (a maximum of 16 sensors <br />could be monitored by the console). <br />Console Software Compatibility <br />• Version 1 or later (TLS -350 Series/TLS-300 Consoles) <br />• All ILS -350 Consoles <br />Compatible Fuels <br />• Unleaded gasoline <br />• Unleaded with up to 5% methanol, <br />15% ethanol, or 15% MTBE <br />• Leaded gasoline <br />• Diesel <br />■ Kerosene <br />• Jet fuel <br />• Aviation gasoline <br />Related Sales Literature <br />Visit our website at www veeder.com <br />for more information on Veeder-Root <br />products and services. <br />• \—Existing conduit <br />or piping <br />Q3 Product <br />Cable to junction box �]: Cable to junctior pipe <br />and seal -off box and seal -off <br />`Sump sensor should: <br />1. Rest on the base of the sump. <br />2. Be positioned as dose to outer <br />wall as possible. Sump sensor' <br />3. Be mounted in a true vertical (installation examples) <br />position. <br />4. Be installed only in a dry sump. <br />.Sump base <br />5 <br />