COMPLIANCE INFO_1991-2008 - Laserfiche WebLink

Home Browse Search

:0;`03:2002 08:13 19163728894 SHIELD, HARPER & CO. PAGE 03 specify that the vapor recovery system is designed, built and equipped so as to conform at the time of original sale and installation with the applicable performance standards and performance specifications and is free from defects in materials and workmanship which could cause the vapor recovery system to fall. Copies of the manufacturers warranty for the system and components shall be made available to the gasoline dispensing facility (GDF) ownerloperator and a -Narranty tag shall be affixed as required in the Certification Procedure. IT IS FURTHER ORDERED that the system. as Installed, shall comply with the procedures, performance standards and performance specifications which the test installation was required to meet during certification testing. If, it the judgment of the Executive Officer, a significant fraction of Installations fail to meet the requirements of this certification, the certification may be Subject to modification or revocation. iT IS FURTHER ORDERED that each PressurefVacJum Vent Valve (PN Valve), Spill Container Drain Valve and Rotatable Adaptor shall be 100 percent performance tested at the factory, and shall comply with the requirements specified in Exhibit 3. iT IS FURTHER ORDERED that each OPW System component listed in Exhibit 1, Figure 1A, shall be clearly labeled by a permanent identification showing the manufacturer's name and model number. IT IS FURTHER ORDERED that the certified OPW system shall be installed and maintained in accordance with the manufacturer's recommended installation and maintenance instructions contained In this Executive Order. A copy of this Executive Order shall be available at each GDF where the certified OPW system Is Installed. IT IS FURTHER ORDERED that any alteration in the equipment parts, design, installation or cperation of the system certified hereby is prohibited and deemed inconsistent with tills certification unless the alteration has been submitted in writing and approved in writing by the Executive Officer or by the Executive Officer's delegate. IT IS FURTHER ORDERED that the following requirements are made a condition of certification. The owner or operator of the OPW System shall conduct, and pass, the following tests no later than 60 days after startup and at least once every 3 years after startup testing; shorter time periods may be specified in accordance with local district rules and regulations. TP - 201.3 Determination of 2 Inch m2O Static Pressure Performance of Vapor Recovery Systems of Dispensing Facilities; Exhibit 4, Static Torque of Rotatable Phase I Adaptors; Exhibit 5 Leak Rate of Drop Tutee Overfill Prevention Device; and Exhibit 6, Look Rate and Cracking Pressure of Preure!Vacuum Vent valves. Notification of testing, and submittal of test results, shall be done in accordance with local district rules and pursuant to the policies established by that district. Alternative test procedures may be used if determined by the Executive Officer, in writing, to yield comparable results. CPW Fueling Components - Phase I Vapor Recovery System — VR -102-A