Laserfiche WebLink
Moa ing System Certification 0 <br /> e Address: 1103 S. MAIN ST. Date of Testing/Service: 06/03/2002 <br /> Results of Testing/Servicing <br /> Software Version Installef6 05 <br /> Complete the following checklist: <br /> El <br /> Yes No Is the audible alarm operational? <br /> El Yes No Is the visual alarm operational? <br /> El Yes No Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> El Yes No <br /> Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br /> ® <br /> interfere with their proper operation? <br /> Yes No x N/A If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> ® Yes ®No ❑N/A monitoring system detects a leak,fails to o orate,or is electrically disconnected?If yes:which sensors initiate positive <br /> shut-down?(check all that apply) Lx Sump/Trench Sensors; ❑x Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks anLgnsor failure/disconnection? Q Yes 0No <br /> ❑ Yes ®No ❑N/A For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.:no mechanical <br /> overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill points(s)and operating <br /> properly? If so,at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes ❑No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement Rarts in Section E,below. <br /> Yes* ©No Was liquid found inside any secondary containment systems designed as dry systems?(check all that apply) ❑Product; <br /> ❑ Water. If yes,describe causes in Section E,below. <br /> © Yes ®No Was monitoring system set-up reviewed to ensure proper settings?Attach set-up reports,if applicable. <br /> ❑ Yes ❑No Is all monitoring equipment operational per manufacturers'specifications? <br /> Lon E below, describe how and when these deficiences were or will be corrected. <br /> E. Comments: <br /> page 2 of 3 <br />