COMPLIANCE INFO_1995-2011 - Laserfiche WebLink

Home Browse Search

• Installation of Model S1300 IC is detailed in this section and Figure B (see page 30). Reference Figure C, (see page 30) for Model SB0014C circuit diagram. Model SB0011C1 and SB0011C4 O 0 Normal Light Normal Light i. Alarm Light Alarm Light Alarm Bell Alarm Silence Test Alarm Alarm Bell Test `Button PAu Silence 7 �utton Bunondible Alarm Alarm Bell Low Voltage Low Voltage High Voltage (Intrinsically Safe) High Voltage (Intrinsically Safe) Conduit Hubs Conduit Hub Conduit Hubs Conduit Hub Model SB0014CI and SB0014C4 o p Normal Light � Normal Light 0 0 Alarm Lights Alarm Lights Alarm Bell Alarm Alarm C Silence Test 0 Alarm Bell Test OButton Button Silence 1 C Button . 0 0 O Button0 0 Audible Alarm Alarm lJ IIJJ pBell Low Voltage Low Voltage High Voltage (Intrinsically Safe) High Voltage(Intrinsically Safe) Conduit Hubs Conduit Hub Conduit Hubs Conduit Hub Dl. Location AWARNING] Locate Control Panel in a Non - Hazardous Area Where an Explosive Environment Will Never Exist. • Control panel can be wall mounted using the provided mounting hardware. D2. Power Circuit • All wiring must be in accordance with local codes. • Control panel is pre -assembled and ready to wire. ❑ A 120 volt AC power source is required. Model SB0011C Shown — Oj® 0O It! f£. O �y a0 Power Circuit Ground (To 120 Volts AC) Lug To Ground • Power circuit wiring (contractor provided) enters the left conduit at the bottom of the control panel and is connected to terminals L 1 and L2. • Circuit breaker (contractor provided) common to other devices is recommended. ❑ This increases probability tank owner will be aware of a tripped circuit breaker. • If there is no power to the control panel, the alarm bell and other warning devices cannot be activated. • In areas where extreme line transients occur, additional surge protection should be installed on incoming supply source. D3. Sensor Circuit • Pre -assembled reservoir sensor is ready to wire (contractor supplied) to the control panel. ❑ For intrinsically safe wiring, use 16 AWG or 14 AWG type THHN or type MTW (contractor supplied) for Model SB control panels and SP switch panels. ❑ For UL rated applications, the maximum wiring dis- tance between the sensor and control panel is 900 feet. • Wiring for sensor circuit enters right conduit at bottom of control panel and is connected to terminals S 1 and G 1. Model SB001IC Shown 0 i. O O Power Circuit Ground Sensor Circuit (To 120 Volts AC) To Ground Lug (To Sensor Assembly) • On four circuit control panel (Model SB0014C) there are four terminal pairs. • Connect a separate sensor to each terminal pairs. ❑ S1, G1 ❑ S3, G3 ❑ S2, G2 ❑ S4, G4 Important: On the four circuit control panel, if less than four monitoring circuits are used, a jumper wire is required to separately connect each unused terminal pair. D4. Optional Wiring Device Circuit • Tank owner may specify additional warning devices to be provided by contractor. ❑ Optional warning device circuits enter panel at the center conduit.