COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

TANK NDSTORAGETANK UNDERGR M CERTIFICATION FORM (Page 4 of 6) MONITORING SYSTEM VIII , MONITORING SYSTEM AND PROGRAMMING Y N NA ' r ' section must be completed if a monitorin Pane is used to perform leak detection monitorin . ry r` This Are the visual and audible alarms operational? r r r sensors visually inspected for kinks and breaks i the cables and for residual buildup to ensure that not r Were all s (� r containment and positioned so that other equipment move free) functionally tested , and confirmed oponda na . Were all sensors installed at lowest point of secondary 1 o r �.- interfere with their ro er o eration? er settings? r Was monitoring system set-up reviewed to ensure prop Was the monitoring p anel' s backup battery visually inspected , functionally tested , and confirmed operational? r r r" of fuel stop at the dispenser if a leak is detected in the under-dispentoring syser contai stem fails to operate or is r r r Does the flow secondary containment moni Does the turbine automatically shut down if the piping stem detects a leak? r7 (" r electricall disconnected? in secondary containment monitoring system Sum f7v Under-dis enser containment I— r Does the turbine automatically shut down if the pip g operational Which sensors initiate positive shut down? Check all that a I • modem) op If alarms are relayed to a remote monitoring station , is all communications equipment (e . g . of "N " above, describe in section IX how and when tese S deficiencies were or will be corrected. For an answer IX, CO Use this section to provide any additional comments about the inventory of the equipment certified. X. IN TANK 'GAUGING TESTING Y N NA Check this box if tank gauging is used only for inventory control . (Do not complete this section .) r Check this box if NO tank gauging equipment is installed . (Do not complete this section .) r This section must be com leted if in-tank au in is used to perform leak detection a d termination , including r' r Has all input wiring been inspected for kinks and breaks in the cables and for proper en ry testin for round faults . to ensure that floats move freely , Were all irkank gauging probes visually inspected for damage and residue buildup r r- r functionall tested , and confirmed o erational? r r r Was accuracy of system' s product level readings tested? system' s water level readings tested? Was accuracy of Were all probes reinstalled properly? t manufacturer' s maintenance checklist completed? when Foran answer of "I Were all items on the equipmendeficiencies were or will be corrected. above, describe in sect►on XI how andCOMMENTS provide any additional comments about the inventory of the equipment certified. Use this section to p Y = Yes , N = No , NA = Not Applicable