COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

STEP 15: DIMPLE REMAININGG HOLES STEP 13: DIMPLE FIRST HOLE 13. Make sure Remove tool . Remove any chips or burrs from the drill- Remove Dimple the next (2) holes as done l in Step g operations Remo D p After Ing operation. Place the assembly on a solid surface. the assembly is on a solid surface when fallen into Using the punch supplied with the 71 SO-TOOL, 71 SO- unchin remove any chips that may TOOLC, and 7150 TOOLCT, align the tip f the ap tube by nch he Inlet tube screw hole# with the drilled hole and dimple the upper striking the punch with a hammer until the drop tube is formeds After punching, move countany chips that may have fsunk hole in the inlet allen into punching, • the inlet tube screw hole. Align punch with I drilled hole Figure 15 m STEP 16: ASSEMBLE OTHER SCREWS Apply black molt' grease to screws and tighten the oth- er (2) screws into inlet tube with a screwdriver as done in Step 14. Use only the taptite screws that are supeied Figure 13 it lbs max, Do not over tigh the unit. Seating torque Is 20 in-lbs min. to 35 in- STEP 14: ASSEMBLE FIRST SCREW Ensure that the drop tube was formed into the counter- STEP 17: APPLY GREASE TO LOWER O-RING AND sunk screw hole as shown In Figure 14 if not return to BODY THREADS Step 13, Apply black moly grease to screw and tighten Apply black molt' grease to the Lower tube o-ring and first screw into inlet tube with a screwdriver. Use only rin Install o-ring in groove just #a tite screws that are supplied with the unit. Seatd bie Qthreads nd the cr shown . g Oke sure coverage is ve ) thep Ingstorque is 201n4bs hould beflu h with the� drop tube,lbDo not over Screw ghta above threads. e ApplYgrease en. around trring Ensure the drop tube Is formed Into wuntetnkhola O-ring groove godythreads Figure 14 Figure 17 R E OIL 11 ZOZO ENVIRONMENTAL HEALTH