Laserfiche WebLink
ETERMIN <br /> TESTABLE PROCEDURE ONLY, FOi1 STANDARD MOD- Rupp ablea along upper tube Land over <br /> top plate on <br /> ELS, PROCEED TO NEXT PAGE" <br /> the float bracket as shown . With the float in the down <br /> STEP 1T: INSTALL SOCKET ADAPTOR ASSY position (as shown in Figure 31) align loop in cable with <br /> Put cable thru threads in inlet tune and out thru cable rivet and top hole in float bracket, Use the rivet as a <br /> port on side of inlet tube. Thread the socket adaptor template to size the loop in the cable and pull cable <br /> assembly finger tight into the inlet tube . Note: the ca. tight and crimp ferrule with crimping tool / pliers onto <br /> ble port on the inlet tube must be in cine with the float cable <br /> scissorst this ' For reference, from theocations Trim excess sleamth wire cutr <br /> where the <br /> as shown previously in Figure 8A. upper tube and valve body meet to the end of the cable <br /> after trimming will require approximately 3 .5" of cable. <br /> Socket <br /> adaptor �'�. Cable over float bracket <br /> I assembly <br /> Air <br /> j`led air <br /> Oil <br /> is is. <br /> 0.0 <br /> 14444 <br /> Cable Seam <br /> port <br /> Figure3T <br /> i STEP 4T: ATTACH CABLE TO FLOAT BRACKET <br /> ;Figure 1T Ensure cable is over the float bracket. Using the sup- <br /> plied rivet align loop in cable with top hole in float <br /> STEP 21'1 PASS CABLE T'HRU FERRULE bracket and pass rivet thru cable loop and float bracket <br /> Pass cable thru ferrule. Loop cable and then pass cable hole. Using rivet tool for 11W dia mandrel attach rivet <br /> back thru ferrule. Keep ferrule loose until cable length and cable to the float bracket. See.last page for list of <br /> is determined in the next step. Note: if cable end frays replacement cable parts. <br /> It may be necessary to trim the cable again to pass thru __�.. Attach rivet to top hole <br /> ferrule. <br /> \ 1 /8" mandrel't " <br /> rivet ,=. <br /> 4 ^ <br /> Ferrule <br /> Figure 4T -- �.- <br /> Trim �`-�__v' STEP 5T• ENSURE PROPER CABLE OPERATION <br /> e <br /> cable � Unthread the socket adaptor assembly from the inlet <br /> after tube and ensure float and poppet move freely when <br /> step 3T Loop f _ socket adaptor assembly is pulled on. it should only <br /> require 3" to 4" of movement In orderto actuate the <br /> float and poppet. Thread socket adaptor assembly fin- <br /> Figure ,2T ger tight into inlet tube after testing. <br /> 13 <br />