Laserfiche WebLink
RECEIVED <br />Appendix A JUL S 0 2020 <br />71 SO Overfill Valve Upper Tube Calculation Workshee�t� R�nf <br />Important: This is meant to be supplemental worksheet and not a substitutelo fo�lbWfiS gTiAiahikA6TH <br />manual instructions. All length measurements are in inches. Please contact the Au!th ii R� iTrisdic- <br />tion (AHJ) and review local, state, and national codes to determine the regulatory requirements governing <br />shut-off capacity in your region, as well as take into account other considerations such as extreme tank tilt. <br />Desired tank capacity for shut-off: <br />Dipstick Number on Tank Chart that corresponds to 100% volume (Y) _ <br />Dipstick Number on Tank Chart that corresponds to SO% (X) _ <br />Upper Tube Reference Number Z=Y-X <br />Upper Tube Depth Inside Tank C = Z-2" <br />Distance from top sealing surface for 71 SO Lip' to inside the <br />top of Storage Tank2 <br />SO%= <br />0 (Y) <br />D (X) <br />0 (z) <br />2 <br />0 (C) <br />A= <br />For Non -Testable 71 SO models only <br />In all cases for non -testable 71 SO models, the top of the valve body must protrude at least 6'/z" into the tank to <br />provide a minimal clearance for proper operation.' Additionally the total Upper Tube Length must beat least 16" <br />of length to include the protective bend in the tube. <br />Is C less than 6'/z" Yes / No <br />If NO, Upper Tube Length (D)= C + A <br />If YES, Upper Tube Length (D)= 61/2 "+ A <br />Upper Tube Length = <br />For Testable 71 SO models only <br />In all cases for Testable 71 SO models, the top of the valve body must protrude at least 6'/2" into the tank to provide <br />a minimal clearance for proper operation.' Additionally the total Upper Tube Length must beat least 14'/2" of <br />length to include the protective bend in the tube. <br />Is C less than 5" Yes / No <br />If NO, Upper Tube Length (D)= C + A - 1 1/2 " <br />If YES, Upper Tube Length (D) = 6'/2" + A - 1 1/2 " <br />Upper Tube Length = <br />' Sealing surface maybe the top of the Face Seal Adaptor, the built in sealing ledge inside some spill containers, or on non - <br />vapor tight applications the top of the pipe nipple <br />2 Some Underground Storage tanks utilize a man way system at the top. Make sure to use the top ofthe storage tank for <br />measurement and not to top of the man way. Consultyour underground tank manufacturer for height of the man way <br />3 This measurement is taken from the seam where the upper tube is attached to the valve body to the inside of the tank top. <br />20 <br />