COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

■ Summary of I These steps are not a substitute for the detailed installation steps contained in the following pages . DO NOT ATTEMPT TO INSTALL THIS PRODUCT BASED ONLY ON THE SUMMARIZED STEPS LISTED ON THIS PAGE 1 ) Read the entire manual front to back , read carefully. Do not just view images . 2) Evaluate the sump , ensure sump material is FRP or steed and the piping is FRP or conduit . 3 ) Remove any necessary components that will obstruct your access to the sump wall . Excavate adequate area on outside of all fittings you will install . 4) Clean each sump . Remove all contaminants , water and debris . Ensure each sump will be completely dry during all installation steps . 5) Secure conduit endpoints so they do not move or act as a lever. 6) Remove the interior boot and all of it's components or sealants from the wall and pipe . 7 ) Push existing bolts back into the backfill . Do not damage the sump wall doing this . 8 ) Properly protect the pipe or conduit against damage . 9 ) Abrade the interior of sump wall around hole until bare fiberglass is shown . 10) Clean , dry and rough up pipe or conduit surface in preparation for bonding . 11 ) Dust off all abraded surfaces with compressed air. 12) Dry-fit your fittings for clean fit against the wall and piping . Mark alignment stripe across the fitting halves and the sump wall with a permanent marker. 13) Bond split fitting to the interior of sump by manually pressing fitting halves firmly against the sump wall using hand strength . 14) Bead excess epoxy around primary seam at the wall and at the pipe . 15) Use acetone to clean the face of each fitting to look like a new install . Clamp halves together tight and re-clean any epoxy that oozes . 16) Allow epoxy to fully cure before testing fitting installation . Do not disturb while curing ! 17) Mandatory Pressure/soap test to verify the fitting installation is good . 6 ikF-Series- Retrofit-& l 5A