COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

SUMIDEN WIRE PRODUCTS CORPORATION SLUG DISCHARGE CONTROL PLAN Page 1/1 Ref: TD-201 APPENDIX # 1 Check List of Pickling and Wastewater balance area Start—Up and Shut—Down MO: Supervisor—and/or—Maintenance Operator, PO: Supervisor—and/or—Pickling Operator START—UP SHUT—DOWN Resp. Resp No. Operation Item MO PO No. Operation Item MO PO 1 Turn on disconnect switches that are X 1 Close main steam valve to acid tank if X in the off position required 2 Open main steam valve to acid tank if X 2 Push mixer stop switch#13&14 X closed Balance tanks—MCC—B 3 Open main steam valve to the coating X 3 Close main steam valve to the rod X bath if closed coating tank if required 4 Check the temp.control panel for X 4 Recorder&Sampler power must X proper operation remain on at all times Push mixer start switches on MCC—B, X 5 Turn P-7,P-7A Switch to OFF X 5 13&14,bal.tanks Look for leaking pipe joints on all lines Turn NAOH(Caustic Soda)and Acid 6 for pH balance control X 6 selector switchs off&Close ball X valves in waste water 7 Turn P-7,P-7A Selector Switch to X 7 Push stop switch for push fan to turn X Auto off Turn 1 st Stage&2nd Stage NAOH Push stop switch for Pull fan(Acid 8 selector switch's to AUTO and open X 8 Bath Scrubber) X ball valves in waste water 9 Turn on main disconnect switch of X 9 Push stop switch for pull fan for X MCC—D if off Coating Bath 10 Check select switch position should X 1 0 Push stop switch for P-1 Pump in X be""manual""MCC—D MCC—D 11 Push start switch of P-1 Pump in X 1 1 Do a Safety Check walk around X MCC—D Wastewater Area 12 Push start switch of pull—fan MCC—D X 1 2 Do a Safety Check walk around X (Acid Fume Scrubber) Pickling Area Push Start Switch of Cross flow vent 13 fan,MCC—D X 14 Push start switch for pull—Fanfor X Coating Bath Notes/Comments: Revised 6/27/14 wm slug plan Appendix 1.xls