Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 329-01 <br />Comnteta tha fnllnwinn rhor4lict• <br />® Yes <br />❑ No* <br />Is the audible alarm operational? <br />® Yes <br />❑ No* <br />Is the visual alarm operational? <br />® Yes <br />© No* <br />Were ail sensors visually inspected, functionally tested, and confirmed operational? <br />® Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment wilt not interfere with their proper <br />operation? <br />❑ Yes <br />❑ No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) operational? <br />® NIA <br />® Yes <br />Q No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br />© NIA <br />fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) ® SumplTrench <br />Sensors, ® Dispenser Containment Sensors. <br />Did you confirm positive shut -dawn due to leaks and sensor failureldlseonnection? ® Yes; ❑ No. <br />❑ Yes <br />❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br />® N/A <br />installed), is the overfill waming alarm visible and audible at the tank fill point(s) and operating properly? It so, at what percent of tank capacity <br />does the aiarm trigger? 0% <br />❑ Yes <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name <br />and model for all replacement parts in Section E, below_ <br />®Yes* <br />❑ No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />ElProduct; ® Water_ If yes, describe causes €n Section E, beiow_ <br />® Yes <br />❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach setup reports, if applicable <br />® Yes <br />❑ No* <br />is all monitoring equipment operational per manufacturers specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E_ comments: COLD START TESTING ALL SENSORS GOOD <br />Monitoring System Certification Page 2 of 4 2/21/07 <br />