COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

Grade Level Spill Containment Manholes 705❑715❑725-GL 05[15❑❑ 25 Gallon❑ Installation Instructions Check For Leaks ❑efore installing a spill container, coat all of the riser pipe Elver❑unit should be tested for leaks prior to, and after, threads with a thread sealant that is compatible with the pouring concrete. If this model comes with a drain, close product in that tank. it. If not, install a 90022-01 test drain kit. Fill the unit Install the spill container b--threading it onto the tank riser complete)❑with water. If the test water level drops at all pipe until it is hand tight. Flo not use the upper cast iron within one hour, then a leak exists this is not an R test .1 ring to full-]tighten the container. Tightening the tank using (heck to see that the drain valve is seated properl❑ If not, the upper cast iron ring can cause undue stress to the then LU❑❑the drain valve several times on a ❑UL❑TJ entire unit. JUS-i []RAIL U❑IT. Replace the valve if it continues to After hand tightening, place a tor❑ue wrench assembl❑ leak. around the lower portion of the tank base and tor.-Ue the If the unit continues to leak, the entire spill container must spill bucket base on a riser pipe to 60-90 ft. lbs. tort-ue be removed from the riser pipe and replaced with another. using an -1-IW chain wrench [part i 901-101-01 rand a R❑-T--ST. torLUe wrench with at least 100 ft. lbs. of torLue range After backfilling the area with pea gravel and pouring )flue to an offset of chain and torLue wrenches, actual concrete, R7]-TF-.ST to make sure that no damage occurred torLue wrench values will be 45-70 ft. Ibs.L After an initial during installation. tor[ue value is obtained, continue to thread the tank base onto the riser pipe until the drain valve is orientated to the riser low spot. otei l All of the tank risers have some out-of-plumb characteristics due to slight tank tilts and rolls. To ®®®a®e properl_drain, the drain valve must be located at the low spot of the riser tilt. The riser low spot is the direction the riser pipe is leaning towards. This is easil❑obtained b❑placing a small amount of c a s a water in the bucket base and turning the bucket a a a until the water runs to the drain valve. ®®®®rel&®r®e a If space is limited (i.e. a retrofit installation to a sawed out d v a a s a d o section of concreteC - 1H Make sure that the inside riser pipe is removed. Figure A: Protect drainage grooves 2) Locate the fitting that the inside riser pipe threads into. 3C `oming down through the top of the unit, use a special socket wrench on the octagonal surface C"o of the fitting to finish tightening it. Do not disassemble the unit. 'V E D • The top edge of the rim must be positioned a minimum of 2"above the drivewa❑level to hto o "",19 provide an ade-bate slope for drainage. • Before pouring cement, place duct tape around the rim, this will keep the cement out of ENVIRONMENTAL HEALTH the drainage grooves when the lid is in place. DEPARTIN IENT See figure A.After cement has solidified, remove and(duct tape or excess cement. lote❑I If Lou want to seal off a drain to test -our unit, install a test drain kit part f 90022-01!.' 3