COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

OPW NO. 1-2100 SERIES GRADE Lbs. max. (4" NPT) LEVEL SPILL CONTAINER INSTALLATION INSTRUCTIONS: Step 7: (See Figure 2) Apply pipe dope to nipple and install. Pipe dope to Step1. be a non-hardening, gasoline resistant pipe thread Per California SB-989, all metal must be protected seal compound. Use only factory made nipples. from direct contact with the elements. Coat stainless Nipples must be cut square and deburred. Torque steel band clamps with the following approved to 125 ft-lbs min. to 250 ft-lbs max. (4" NPT). coatings. OPW SL-1100, 3M Underseal 08883 or Torque value is based on rotation at the center of Polyguard Mastic CA-9. Only the threaded pipe. For standard cover models install adaptor and hardware needs to be coated in the field. dust cap. For sealable cover(1 SC) models, install a standard 4"pipe cap to support adjustment system. Step 2: (See Figure 1 &2) (Adaptor and dust cap must be installed in sealable Set riser pipe. "L" is the distance between the top of cover(SC) models after concrete has dried. the riser pipe and finish grade. Note: Nipple length is determined by measuring Note: The "L"dimensions below factors in a from the bottom of the threaded portion of the base 1"slope to grade. to the bottom of the cover. Then subtract 2"for clearance, height of adaptor and height of cap. Model Series "L" Dimension Range of nipple lengths that can be used in all of the 1-2100, 5 Gal. (Comp. Base) L=15 5/8" (40cm) OPW spill containers: 4" minimum to 14" 1-2100E, 7.5 Gal.(Comp. Base) L=19 5/8" (50cm) maximum. 1-2115, 15 Gal. (Comp. Base) L=19 5/8" (50cm) 1-2100C, 5 Gal.(Cast Iron Base) L=14 1/2" Finish Grade (37cm) 1-2100EC, 7.5 Gal.(Cast Iron Base) L=18 1/2" (47cm) 1-2115C, 15 Gal. (Cast Iron Base) L=18 1/2" (47cm) Note: If using OPW FSA-400, add 3-1/4"to Dimension "L". Fi urel If using OPW FSA-400-S, add 1-3/4 to Dimension 111 NOTE:FSA-400-S will only work with Cast Iron Finish Grade Slope 1"min. Base. . o Step 3: ° °'!ofRiser �3 Deburr and thoroughly clean riser pipe. Apply pipe ° °.o° ' RETE'°dope to riser threads. Pipe dope to be a non- o o I vE hardening, gasoline resistant pipe thread seal °• °compound. p °rStep 4:Install OPW FSA-400 Face Seal Adapter onto riser L using the OPW61SA-TOOL. Torque to 125 ft-lbs min. to 250 ft-lbs max.(4" NPT). Apply pipe dope to ofFSA-400. Pipe dope to be a non-hardening, in base gasoline resistant pipe thread seal compound. Step 5: iser Pipe Install spill container by rotating the mounting ring NMI until hand tight. NOTE:Do not attempt to completely tighten the container by using the mounting ring Riser Pipe Step 6: Finish tightening the spill container with the OPW 61 SA-TOOL. Torque to 125 ft-lbs min. to 250 ft. 3