Laserfiche WebLink
Solvent and cutting fluid <br />Here at LFW we use solvent for cleaning/ wiping down surfaces the shop. Cutting fluid is to assist <br />in the fabrication of a metal part. <br />Used Solvent and cutting fluid <br />If we do have waste solvent or cutting fluid the proper procedures is to: <br />-Drain into a 5 gallon bucket and label with a Hazardous Waste Label. Please write the <br />date on the accumulation line of the label or notify the office so that it can be properly done. <br />Used Shop Rags <br />Around the shop we use shop rags to help keep the work environment clean. Because our rags <br />contain oil we must dispose of them properly in the USED SHOP RAG receptacle located in the <br />machine room. At the end of every work shift you are responsible for the rags in your work area. <br />Please gather your rags and dispose of them in the proper receptacle <br />Ground Water Drain <br />There is (1) one ground water drain located in the center of the yard. We need to be very careful <br />when it comes to spills and ground contamination. <br />If there is a spill, and it might come in contact with our ground water drain, the proper procedure <br />is: <br />-Use floor absorbent and shop rags to prevent the spill from entering into <br />the ground water drain. <br />If you are not able to contain the spill and prevent ground drain contamination please notify the <br />office so that we can contact The Environmental Health Department. <br />�mm <br />Rachelle D. Brown <br />Safety Manager <br />