Laserfiche WebLink
STEP 5 DAN two'/"holes at the 12 o'clock position in the housing flange. <br /> These sMuld be positioned 318"off the outer edge of the stiffening <br /> ribs.One hole is for filling,one hole is for venting. <br /> STEP 6 Reinstall the interior flex boot and loosely tighten the band clamps <br /> to hold the boot in position.Pull the boot back just enough at the <br /> top to expose the fill and vent holes and re-snug the clamps. Fill <br /> the entire boot cavity with Blue Fill 4036 until the filler begins to <br /> run out of the vent hole.There should be no visible air bubbles in <br /> the boot. Once the boot is full, carefully loosen the large clamp <br /> and push the top of the boot to the fully seated position and re- <br /> tighten all the clamps. <br /> STEP 7 Clean up any excess material quickly as it sets up rapidly and <br /> allow 24 hours for the Blue Fill 4036 to fully set before testing. <br /> BLUELINE • Drive,Yubo Citv, CA 95991 - Phj866)267-9765 Fax:[866]310-3848 <br />