Laserfiche WebLink
BCE#14573 <br /> 1. MONITORING: All monitoring equipment must be listed in the State Waster Resources Control Board <br /> Division of Clean Water Program Local Guidance Letter 113. <br /> Check Code <br /> Box Section <br /> All secondary containment units (e.g. tank annular spaces, secondary piping, sumps, <br /> ® <br /> 23 CCR under-dispenser containment, etc.) monitored for leaks using approved electronic leak <br /> 2636(f) detections stems. <br /> All sensors must be located at the lowest possible point so that they may detect a leak <br /> at the earliest opportunity. <br /> Electronic monitoring sensors located at the following points: <br /> ° At the bottom of the interstitial space of each secondarily-contained tank, <br /> positioned as near as possible to the bottom of the tank. <br /> Manufacturer Veeder-Root Model 794380-303 <br /> ° In each collection sump, positioned as near as possible to the bottom of the <br /> collection sump. Additionally, in any sump acting as secondary containment for <br /> unused tank openings which connect to the primary space. <br /> 23 CCR Manufacturer Veeder-Root Model 94380-323 <br /> ® 2632 <br /> 2630(d) <br /> ° In dispenser pans which do not drain into secondary containment piping. <br /> (Note:A mechanical switch which triggers a shear valve may be substituted but <br /> this system will not qualify for the annual line tightness test exemption under 23 <br /> CCR 2636(8)). <br /> Manufacturer NSA Model <br /> ❑Along secondarily-contained pipe runs which do not meet the 114 inch-per-foot <br /> slope requirement, positioned in the depressed or low-lying areas. <br /> Manufacturer Veer-Root Model 794380-208 <br /> 23 CCR Automatic line leak detectors installed to monitor underground pressurized piping. <br /> 2636(f) <br /> ® HSC Manufacturer FE Petro Model STP-MLD-D <br /> 25290.1 h <br /> 25290.2 <br /> Alarm panel provides both audible and visual alarms. It is located in a protected area <br /> and within sight and hearing distance of on-site personnel and hard-wired to a <br /> 23 CCR dedicated circuit. <br /> ® 2632(c)(2)(B) Existing <br /> Manufacturer Veeder-Root Model TLS350R <br /> J. OTHER COMPONENT INFORMATION: <br /> COMPONENT MANUFACTURER MODEL COMPOSITION <br /> Containment DW PTS (WT34) FRP <br /> SUMP Solutions <br /> UNDER-DISPENSER N/A <br /> CONTAINMENT <br /> PENETRATIONS Bravo T2 <br /> 2-TS-AD-CO FRP <br /> Revised 8/1/11 8 <br />