Laserfiche WebLink
0 .0 <br />f7, <br />D. Results of Testing/Servicing <br />Software Version Installed: ( t% <br />Co iiinlete the followinLy checklist: <br />ds ❑ No* <br />Ishdible alarm operational? <br />Yes ❑ No* <br />Is the visual alarm operational? <br />J Yes ❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />,"Yes ❑ No* <br />Were all sensors installed at lowc.st point of secondary containment and positioned so that other equipment will <br />not interfere with their proper operation? <br />^station, <br />❑ Yes ❑ No* <br />If alarms are relayed to a remote monitoring is all communications equipment (e.g. modem) <br />N/A <br />operational? <br />Yes ❑ No* <br />❑ N/A <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />monitoring system detects a leak, fails to operate is electrically disco ted? If yes: which sensors initiate <br />positive shut -down? (Check all that appl)) Sump/Trench Sensorv, Dispenser tainment Sensors. <br />CoYes; ❑ <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? No. <br />❑ Yes ❑ <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />mechanical overfill prevention. valve is installed), is the overfill warning alarm visible and audible at the tank <br />/PIN/A <br />fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % <br />❑ Yes* No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that appl}) <br />❑ Product; ❑ Water. If yes, describe causes. in Section E, below. <br />Yes ❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />Ies 1 ❑ No* 1 Is all monitoring equipment operational per manufacturer's specifications? �I <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />