Laserfiche WebLink
August 14, 2008 <br />San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />Stockton, California 95202-3029 <br />Mike Flores <br />Stockton Service Station <br />808 N. Union Street <br />Stockton, CA 95205 <br />Fax: (209) 464-8349 <br />Website: www.sjgov.org/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />!7D <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent via Fax and Mail <br />Subject: Shell Food Mart, 2320 El Dorado St, Stockton, CA (SR0055104) <br />The San Joaquin County Environmental Health Department (EHD) has completed the review of <br />the application for permit to change the Veeder Root monitoring panel TLS 350 ECPU board. <br />The monitoring panel will be upgraded with an ECPU2 board with NMEM and V28 software. <br />This repair will require a "system cold start" according to the service manual. The permit has <br />been approved with the following conditions: <br />Conditions of approval: <br />1. Contact the local fire department, local planning or building department and the San <br />Joaquin Valley Air Pollution Control District for any applicable permits. <br />2. Any changes shall be submitted to the San Joaquin County Environmental Health <br />Department (EHD) for approval prior to commencing work. All new addenda supercede <br />the previous ones. <br />3. Before the alarm history is cleared by the "cold start", a current printout must be <br />created and available for EHD inspection. <br />4. Contact Garrett Backus (209-468-2986) to arrange the following inspection(s) (a 48-hour <br />notice is required): <br />a. The EHD must witness the testing of the functionality of the monitoring system <br />to ensure that monitoring has been restored to meet the requirements of <br />California Code of Regulations Title 23 and the Health & Safety Code. All <br />monitoring system sensors must be tested. Electronic line leak detectors must be <br />tested, if installed at this site. <br />5. A "Certification of Installation / Modification" form shall be submitted by the owner <br />or the owners' agent [pursuant to (CCR) 2635(d)] before this upgrade will be considered <br />complete by EHD. <br />6. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />Page 1 of 2 <br />