Laserfiche WebLink
April 21, 2009 <br />Ll <br />San Joaquin County <br />Environmental , I <br />•11 East Main Street <br />Stockton,California95202-3029 <br />•=— Mzsy&7777777 <br />Phone:1' 468-3420 <br />1'464-0138 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Liddy McKenzie Sent via Fax and Mail <br />Gettler Ryan Inc. <br />6747 Sierra Court, Suite J <br />Dublin, CA 94568 <br />Fax: (925) 551-7888 <br />RE: ARCO 2130, 7906 N El Dorado St, Stockton (SR0057078) <br />The San Joaquin County Environmental Health Department (EHD) has completed the review of <br />the application for a permit to install a Veeder Root 323 liquid sensor in the under dispenser <br />containment 3/4 at the above noted address. The permit has been approved with the following <br />conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution Control <br />District for any applicable permits and requirements. <br />2. Contact Garrett Backus to arrange the following inspection(s) (a 48 hour notice is <br />required): Inspection of the functionality of the 323 sensor. <br />3. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all of the <br />following: <br />a. One of several permissible valid, current contractor's licenses issued by the <br />Contractors State License Board (may be issued to the installation company), and <br />b. A valid, current California UST Service Technician certificate issued by the <br />International Code Council (ICC), and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced, and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />4. Permit expires 180 days from date of approval. Note: If an extension to the expiration <br />date is required, a written request must be submitted to this office prior to the expiration <br />date. <br />5. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />6. Any changes in information and scope of work must be submitted to EHD for approval <br />prior to commencing work. All new addenda supersede the previous ones. <br />Page 1 of 2 <br />