COMPLIANCE INFO_1996-2004 - Laserfiche WebLink

Home Browse Search

BRAVO CONTAINIT TM CLEAR SECONDARY PIPING CONTAINIT, DON'T REPLACE IT! THE ANSWER FOR ADDING SECONDARY PIPE OVER NEW OR EXISTING PRIMARY PIPE — BRAVO'S CONTAINIT. ContainIt clear polyvinyl chlo- ride resin split pipe and fittings, is extrusion molded with ports and fittings injection -molded for precise fit. Lightweight, strong and rigid, it installs around any type, brand or mate- rial of primary pipe. Since pri- mary is not replaced, extra labor costs and additional station down-time are eliminated. WHY IS IT CLEAR? ContainIt makes primary pipe and fittings fully visible. Spotting a break or leak in the primary is simple, and repairs can quickly be made. HOW IS IT INSTALLED? •ContainIt is shipped in match- ing halves with predrilled bond- ing ports on the pipe seams and fittings. •Halves are joined by injecting a special adhesive into the bonding channels. joints are permanently bonded and leak -free. No hard- ware is needed. *Few tools needed for installa- tion. •ContainIt lets you easily inspect the bonding channels for a com- plete seal. If you find a gap, sim- ply drill another port and inject adhesive into it. No ends to sharpen. *The channels meter and con- trol the adhesive flow for smoother application. Wide external flanges Primary pipe can be Centralizers support provide superior bond virtually any material pipe while allowing strength when compared leak detection cables in to fabricated fitting ace annular s Fitting clip locators P is Injection molded Bonding adhesive pre -drilled injection ports • fitting halves channels meter and l p control flow of on split pipe and fittings adhesive *Circular centralizers center and support the primary. They elim- inate hydraulic hammer wear or contact between the two pipes - lessen the chance of friction or excessive wear. *Centralizers channeled to hold interstitial monitoring wires. *Withstands 65 pounds of pres- sure when hydrostatically tested. *Supports backfill, when firmly bedded, without bending, fold- ing or pinching. Available in 4 -inch and 6 -inch diameters. Centralizer centers and supports most sizes of primary pipe. CONTAINIT ACCESSORIES: *Fitting clips (included) hold fit- tings in place for bonding. A hammer drives them into place. •Pipe clamp is available from Bravo. Eases snapping the pipe halves together. *Drill and GSR Counterbore drill bit for drilling extra injec- tion ports and crossover holes in the pipe assemblies. •Injection gun and compressed air are used to inject the bond- ing adhesive. ContainItTM is a registered trademark of the R & G Sloane Mfg. Co., Inc. • Injection Gun Used for injecting the Containit adhesive.