Laserfiche WebLink
Manual No. am65 <br />September 1, 1991 <br />Smith Fiberglass Products of- <br />fers RED THREAD U secondary <br />containment piping system for <br />use with Smith Fiberglass Prod- <br />ucts primary piping systems. The <br />telescoping pipe, available in 15 <br />and 304i. lengths, a||uvvs com- <br />plete (l00%) inpsccdnn of the <br />primary product piping. The <br />containment sleeve and adapters <br />shown on page and the pipe <br />penetration seals shown onpages <br />4, 5 and 6 complete the RED <br />THREAD || Secondary Contain- <br />ment Telescoping Pipe System. <br />Specify the part numbers shown <br />when ordering. <br />When designing orinstalling a <br />secondary containment system <br />using the recommended Smith <br />Fiberglass Products parts con- <br />tained in this manual, consult <br />on'tainedinthiornanua|,consu|t the <br />owner oroil company engineer <br />for approval. <br />installation procedures for the <br />telescoping system are very simi- <br />lar to Smith Fiberglass Products' <br />other secondary containment <br />systems. Therefore, this manual <br />must boused inconjunction with <br />Manual No. 132160, installation <br />instructions for primary and sec- <br />ondary containment piping. <br />The product pipe iycontained <br />by three pieces of containment <br />pipe. The three sections o{con- <br />tainment pipe consist oftwo pieces <br />w{pipe which are one size larger <br />than the product pipe and one <br />piece of pipe which is two sizes <br />larger than the product pipe. Use <br />V{this "nested pipe" allows "tele- <br />scoping" one pipe section into <br />(or above) the adjoining section. <br />Therefore, the entire product pipe <br />isexposed for inspection. <br />To complete the system, it is <br />necessary to install tvoconCen- <br />14211111:141 <br />thc reducers that connect the <br />two different sizes of contain- <br />ment pipe. Installation procedures <br />ontain'rnentpipe.|nstaUadonpomcedunes <br />such assurface preparation, ad- <br />hesive app|icabon,andsonn,any <br />shown on pages 24 and 25 of <br />Manual No. 132l6O. <br />Possible configurations for a <br />telescoping pipe system are shown <br />in Figure l and Table |. <br />PRODUCT <br />SECONDARY <br />SECONDARY <br />TELESCOPING <br />PIPE SIZE <br />PIPE S <br />PIPE SIZE <br />REDUCER SIZE <br />NOTE: Currently, u^.u^and ~rf!pecan uesupplied with auL LABEL. <br />0RED THREAD isuregistered trademark mSmith Fiberglass Products Inc. <br />��.Patent No. 4,mm,4w <br />SMITH FIBERGLASS PRODUCTS INC. °« SUBSIDIARY opA.uom�*con�n�mw <br />2700 W. uon+ LITTLE ROCK, 501-568501-568-4010^n recoo ° �sao ° FAX m�� <br />x xao*o ° n^m 910-722-73 77 <br />