Laserfiche WebLink
c: <br />11 <br />S. BRAVO *137 <br />Y E ' INC. South Anderson Street <br />Los Angeles. CaLfOMI.- 90033 <br />(213) 265-1-468 <br />B-200 BULKHEAD FITTINGS INSTALLATION <br />Bulkhead fittings are availei6-10 in- i-- <br />• <br />sizes 1/2, ®• '•---�_°/-2-•...NE7' <br />and 1 1/4• I` N /#''-*-Ioctr�cal'. <br />conduit and� yYE for <br />LOCKING NUT electrical conduit. Consu -IucwT your <br />FLAT WASHER Bravo distributor. RUBBER SEAL <br />B-2 <br />RUBBER SEAL Cut appropriate hole size in pan of the <br />FLAT WASHER 3-2410, at the desired location. <br />STATIONARY NUT <br />With the long end up, place 1 flat <br />rasher and i rubber seal on to fitting. <br />Insert fitting thru the bottom of the <br />11-290, with the stationary nut (short <br />end) down, place i rubber seal and 1 <br />flat washer on to fitting and thread <br />ressinIng nut onto unit. Tighten nut'' <br />SEAL OFF to proper tension to prevent a liquid <br />leak. <br />The RYE bulkhead fitting are used to <br />provide continuous conduit run to <br />1 1/26 NIPPLE electrical seal off. A threaded 1 1/2• <br />nipple is use to prevent a liquid path <br />from the B- A nipple of sufficient <br />length to rise above the top of the <br />i <br />2-2 or an appropriate sealing material <br />10 CONDUIT can be with shorter length. Method <br />is normally dictated by local code <br />requirements. - -- - <br />AYE OS �� RYE Bulkhead Fittings are inserted from <br />•O• RING the top of the 3-296 down. After <br />®- 2*0 insertion the Rubber Seal, Flat Washer <br />RUBBER SEAL and locking Nut are installed. <br />FLAT WASHER <br />LACKING NUT <br />All surfaces should be made as clean as <br />possible, prior to the tightening of any <br />bulkhead fitting into place. <br />ALL FITTING SHOULD BE TESTED FOR LI®UID <br />TIGHTNESS, AFTER INSTALLATION. <br />